GENERAL RULES

The 2019 editions of the following documents are applicable:


AIRCRAFT MODEL REQUIREMENTS MULTIROTOR


RADIO CONTROL EQUIPMENT

The recommended frequency band is 2,4 GHz. Any 2.4 GHz radio control equipment may be used. Competitors may also be authorized to use other equipment, such as for example TBS Crossfire module (868 MHz and/or 433 MHz).
Competitors will be requested to mention the frequencies they will use prior race.


VIDEO SYSTEM

The video system is based on 5.8 GHz frequencies. The VTX should be a quality one, with 25mW output power. The power and the spread channel on the band could be measured ahead of each race.

Competitors must bring their own video receiver (googles) and antennas

​Important: all videos (DVR) races will be saved automatically.

​Note: Any competitor who does not respect the maximum emission power or other restriction for use of the video transmitters defined by the organiser may be disqualified from the contest.


LED LIGHT UNIT

LED lights unit are allowed, but are not mandatory.


 

ELECTRONIC TIMING SYSTEM

The organiser will use Immersion RF LapTimer.


OTHER REQUIREMENTS 


IDENTIFICATION MARK 

Each model shall carry the national identification mark followed by the FAI Sporting Licence ID number (or the National FAI licence). The letters and numbers must be at least 6 mm high and appear at least once on each model


PROTEST

Any protest must be presented in writing and must be accompanied by a deposit fee of 50 Euros. The deposit is returned only if the protest is upheld.


FAI SPORTING LICENCE - FAI DRONE PERMISSION

Each competitor must possess a valid FAI Sporting License or FAI Drone permission.


OFFICIAL LANGUAGES

The official languages will be English and French.


OFFICIALS

FAI Jury

- Bruno DELOR (FRA)

- Frederic THEUREL (FRA)

- One jury members will be nominated from the competitors. An alternate jury member will also be nominated for the competitor jury member, to serve on the jury when considering any protest involving this competitor jury member.


 

Imprimer